Wireless
Overview The purpose of this Early Access post is to offer you with a chance to experience the new features and updates of TP-Link Omada products in advance, and also give us TP-Link the opportunity t
Firmware UpdateHighlighted ThreadOfficial
12Helpful
83160Views
Hi all, Recently been trying to setup a EAP650-Desktop for multi-SSID (some 2.4GHz and some 5Ghz). When setting up 2.4GHz from a factory reset no issues. But the moment I try and connect to a 5GHz SSI
HealthInstallationVLAN & Multi-Networks
By
edwardslc
0Helpful
20Views
I have simple mesh network, EAP 610 hooked up to a router that is hooked up to my internet access CP-220 hooked up to that router as a hardware controller EAP 603 on one building. EAP 225 on another b
By
colorado77
0Helpful
23Views
Hi! Im having this problem on a location where i have many EAP-773's running. 6ghz is disabled. All new copper CAT-6 cabling, SG2210MP POE switch, OC200 controller. Everything is on latest firmware. I
0Helpful
99Views
I am hitting some quite serious issues with the Omada EAP products, after an initially smooth setup. I will describe the topology. I purchased 2x EAP650. Root EAP650 is connected to a managed switch.
Network ConnectivityMeshRoaming
By
Oliver1992
· Latest post 11 hours ago
by Oliver1992
0Helpful
1148Views
Hello. We have a private network (172.16.xx.xx) that we use for devices around the city. In some places we use a cpe510, programmed as an AP, connected to this network at the end of an area. Then we h
Network ConnectivityInstallationTopology
By
Olamel
0Helpful
28Views
3 story house. There are two EAP610 and one EAP670 on the ground floor, one EAP610 on the first floor, one EAP610 on the second floor. Have two solar microinverter on the roof. They should connect to
Network Connectivity
By
Leosimoni
0Helpful
31Views
This Article Applies To: EAP723 V1, Fully Adapted to Omada SDN Controller v6.2 or above; EAP770 V2, Fully Adapted to Omada SDN Controller v6.2 or above; EAP772-outdoor V1, Fully Adapted to Omada SDN C
9Helpful
10275Views
hello everybody, i am trying to set up an EOGRE tunnel between an Omada Eap (site 1) and a raspberry pi (site 2). Does anyone know of a good beginner-friendly guide or tutorial? My goal is to terminat
By
prisko
· Latest post Yesterday
by Vincent-TP
0Helpful
161Views
In reviewing the logs, I see that some 15 minutes ago the EAP detected a radar and changed its channel from 100 to 108. However, the channel change supposedly did not occur. Using the Wi-Fi Analyzer t
Network Connectivity
0Helpful
107Views
I have recently experienced a power outage, during the firmware update process of my EAP225-Outdoor device. Now the device is not starting up. I am quite ceratin, because the LED remains solid after t
Network ConnectivityInstallationFirmware UpdateHealth
0Helpful
317Views