Wi-Fi Routers
My access point is the archer c50 / ac1200 and i dont know why Im only getting Internet :100 mBps full duplex when my internet connection on my modem is 1Gb?
Access Point Mode
0Helpful
190Views
My archer C7 router in AP was working perfectly fine, but then it suddenly stopped working overnight. Wifi and lan device cannot connect to the internet. Doing a tracert shows that the packet arrives
Access Point Mode
2Helpful
820Views
The second LED (Internet) of the device is constantly blinking. The quick installation guide says: "The WAN/LAN port is connected but internet is unavailable when in Router or Access Point mode.". I a
Access Point ModeNetwork ConnectivityTravel/Portable Routers
0Helpful
169Views
Hello, I bought a BE800 router and configured it as the main router. I saw that the wifi signal is not strong enough all over my house so I bought another one. How should I configure the second one to
Access Point Mode
2Helpful
219Views
I've bought Archer C80 plus RE315 for my home network setup. Before the firmware had an option to support Ethernet-backhauled mesh (since the only points I could put the devices are located in a way t
Firmware UpdateEasyMeshAccess Point Modeexception
1Helpful
283Views
Hi, At home I have the following setup - a tp-link switch modem connected to the internet and 2 routers (both AX53 3000), connected to that switch. I want to set them up in such a way that both belong
Access Point ModeEasyMeshInstallationNetwork Connectivity
2Helpful
439Views
We have two floors in our home, to make the range reach upstairs we used a tp link router in Access Point Mode which caused the downstairs WiFi to slow down till 2mbps (average is 55mbps) and upstairs
Access Point ModeWDS/Range Extender Mode
By
scattagain
· Latest post 2024-01-24 18:54:55
by terziyski
1Helpful
214Views
Hey there, I've purchased a AX1800 with the scope of using it as my main router due to better WiFi signal that my ISP's device. The ISP is Vodafone in Europe, and it's using a coaxial cable. I've set
Access Point Mode
0Helpful
485Views
This Article Applies to: Archer AX12 V1 working on AP Mode Issue Description: When Archer AX12 V1 works on AP mode and there are multiple APs in the same network with the same SSID, some customer migh
Access Point ModeRoamingOfficial
4Helpful
2867Views
Hi, I got an AX53 router that i have been only using in AP mode, but recently even though the link is with a cat6 cable and it does connect at 1Gbps at first but after a while it revers to 100mbps con
Access Point ModeNetwork Connectivity
1Helpful
696Views