Deco
To Whom It May Concern, Any update on the availability date of the 1.6.0 firmware version for the M4 V2, that includes functionality of the latest recently released firmware update for V4 ? Or as an a
Firmware Update
By
JaapHoutman
· Latest post 2024-01-18 17:09:28
by Kizovinh
24Helpful
3475Views
The same location setup for 2 years without issue. Once it's updated to latest firmware, it keeps disconnecting from main deco. Attached log below Thu Jan 18 23:27:01 2024 daemon.err udhcpd[16058]: cl
Network Connectivity
By
miliew
· Latest post 2024-01-18 16:09:29
by Alexandre.
0Helpful
166Views
Hola He activado la función de red IoT en el dispositivo y la mayoría de los productos tuya se conectan correctamente, pero de momento tengo 4 dispositivos diferentes que no se conectan. Si usas la re
By
AndresMBX55
· Latest post 2024-01-18 15:39:54
by AndresMBX55
1Helpful
103Views
Hello I need to configure a DECO XE75 setup at a place where there is only one cable modem without Wi-Fi and zero mobile network coverage. I am stuck at the configuration as the setup asks me for my T
0Helpful
239Views
5Ghz speed to low I use the 5Ghz band. Computer just a few meters from router. Full signal. Connected to 1000Mb fiber. Only gets a wifi speed of max 500Mb/s. According to technical data, the router sh
Decos7 speed
2Helpful
202Views
Upgraded my Deco units (2 of them). After upgade the fastest Wifi Speeds I can get is 50 mbps even when standing right beside either unit. When I test from the Deco app from the router out to the ISP
Firmware Update
By
AndyK1067
· Latest post 2024-01-18 12:50:03
by Alexandre.
1Helpful
323Views
Hi Folks, Today I extended my network (I first was running with 4x Deco X50) with two Deco X90. According to installation I had to make the best Deco node as Primary Node (connected with WAN) I transf
MatterInstallationConnection PreferencePreferences
3Helpful
242Views
Hi there. Can I use myTP-Link DecoX50 AX3000 5G Mesh WiFi router without a SIM card since I have got a fiber network, and if so. How to connect the router
By
RolloFlame
· Latest post 2024-01-18 06:11:06
by David-TP
0Helpful
77Views
Today when I suffered an internet outage I discovered something strange. I have 3x X60 in a mesh configuration and the primary is acting as a router (with DHCP) connected to my fiber media converter.
Address ReservationLAN
0Helpful
86Views
Hello, i need some advice. So my question is : How can i make it efficiently changing password without going one by one to deco APs? because we will change wifi password weekly. Right now i'm designin
Access Point ModeDeco Ethernet BackhaulNetwork ConnectivityWi-Fi Access Controlchange password
By
TheNewbie92
· Latest post 2024-01-18 03:43:37
by TheNewbie92
1Helpful
293Views