Deco
How to force a node to use PLC rather than wifi. Since the most recent firmeware update they always use wifi even when there is a very weak signal.
By
FHR
· Latest post 3 weeks ago
by TravellingTechy
3Helpful
762Views
Same issue as reported here: https://community.tp-link.com/us/home/forum/topic/99275 wondering if this is a known issue? setup is: M9pro --wired--> M9pro x 2 all the guests I can see in the deco app a
Deco Ethernet BackhaulNetwork ConnectivityGuest wifi
By
RandomStranger
· Latest post 3 weeks ago
by RandomStranger
0Helpful
155Views
Dear all I would like to set up a mesh network based on three deco devices, they would be wired so as to have an Ethernet back haul, and they would be in access point mode. Question is whether the mes
Deco Ethernet Backhaul
1Helpful
112Views
Suddenly, last night, had this dreaded solid Red light on the base unit. Internet was fine - checked with old router. Tried a few things but ended up having to reset the unit and setup from scratch! T
1Helpful
189Views
Hello, I have a network that uses 4 Deco M4 V2, firmware 1.6.2 Build 20240308 Rel. 55841, the problem is that all 3 satellites are conecting to the main Deco unit, leading to poor signal for 2 of them
1Helpful
134Views
I need a bandwidth control for my Deco E4. All networks like primary and secondary has the same bandwidth and it's killing me ! My guests cant run the primary networks internet to not working anymore.
Guest NetworkBandwidth Control/QoS
By
Stephan777
· Latest post 3 weeks ago
by ImtiazAli
1Helpful
44Views