TL-WR940N Static route + bridge + external access

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-WR940N Static route + bridge + external access

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-WR940N Static route + bridge + external access
TL-WR940N Static route + bridge + external access
2017-09-01 20:41:26
Model :

Hardware Version :

Firmware Version :

ISP :

Hi, I've a problem to conect to my TL-940n outside my internal network.
My scenario:

I've receive my internet conection by the ONU fiber (pppoe + routing) and the 4 LANs are in bridge mode. I created a static route to access my tp-link outside my home, the firewall is set (8082 port), but still... I made contact with TP-link support, and was informed that the router can't be accessed without active DHCP (!?!?!). It is possible a workarround or its a software limitation?
  0      
  0      
#1
Options
1 Reply
Re:TL-WR940N Static route + bridge + external access
2017-09-20 16:15:12
Why not? :eek:
Do you want to access the web UI? If you set static IP for the router, then you can open the port(normally port 80) for the router on your fiber modem, then you can access it from external network.
How do you want to access the router?
  0  
  0  
#2
Options