Signal strength using router mode (default mode)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Signal strength using router mode (default mode)
Model :
Hardware Version :
Firmware Version :
ISP :
Hello,
I bought the system around three weeks ago and have been using it in the default router mode, with the main being connected to my gateway in the basement and the other two connected wireless on each floor. I have noticed my speeds are quite low and the two routers connected wirelessly tend to lose signal and flash red for a few seconds before fixing itself.
Is it possible to improve performance/speed if I plug in the other two routers to the CAT5 ports in my house in Access Point mode? If so, do I need to change from the created Deco SSID to my main gateway SSID?
Hardware Version :
Firmware Version :
ISP :
Hello,
I bought the system around three weeks ago and have been using it in the default router mode, with the main being connected to my gateway in the basement and the other two connected wireless on each floor. I have noticed my speeds are quite low and the two routers connected wirelessly tend to lose signal and flash red for a few seconds before fixing itself.
Is it possible to improve performance/speed if I plug in the other two routers to the CAT5 ports in my house in Access Point mode? If so, do I need to change from the created Deco SSID to my main gateway SSID?
