Can’t access admin page after factory reset
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Can’t access admin page after factory reset
Model :
Hardware Version :
Firmware Version :
ISP :
I’m resetting my TP-Link N600 router to become an access point only. I could access the admin page on 192.168.1.1 perfectly well and decided to do a factory reset to make a clean start on the reconfiguration. Now I cannot access the admin page. I am connected directly on the LAN port through Ethernet cable. Have tried lots of ideas from previous threads but no luck. Any ideas?
Hardware Version :
Firmware Version :
ISP :
I’m resetting my TP-Link N600 router to become an access point only. I could access the admin page on 192.168.1.1 perfectly well and decided to do a factory reset to make a clean start on the reconfiguration. Now I cannot access the admin page. I am connected directly on the LAN port through Ethernet cable. Have tried lots of ideas from previous threads but no luck. Any ideas?
