Setting Time and Time Zone EAP245 Attached to Linux EAP Controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Setting Time and Time Zone EAP245 Attached to Linux EAP Controller
Setting Time and Time Zone EAP245 Attached to Linux EAP Controller
2018-08-10 10:14:11
Model :

Hardware Version :

Firmware Version :

ISP :

I have 2 EAP245 APs controlled by a Linux box rung the EAP Controller. The APs are not picking up the timezone from the controller and thus the times are off. I SSH'd into them and they are defaulting to UTC instead of the timezone on my controller. Is there a way to set the timezone on the APs when they are controlled by a Linux Controller? I know when they are NOT attached to a controller, the is a setting in the WebUI of the AP to do it...this doesn't exist in the Controller WebUI that I can tell.

Thanks,
0
0
#1
Options