QSS problem
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
QSS problem
Region : Malaysia
Model : TL-WN722N
Hardware Version : V1
Firmware Version :
ISP : TM Net, WinXP
QSS always starts scanning from channel 1. It stops scanning before it can reach my channel, ch 10.
How can I change the scan sequence or specify a channel no. or select an AP for QSS?
I can't change the channel no nor press the QSS button on the AP.
Thanks, Adam
Model : TL-WN722N
Hardware Version : V1
Firmware Version :
ISP : TM Net, WinXP
QSS always starts scanning from channel 1. It stops scanning before it can reach my channel, ch 10.
How can I change the scan sequence or specify a channel no. or select an AP for QSS?
I can't change the channel no nor press the QSS button on the AP.
Thanks, Adam
