Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > Need to extend a Deco m9+ mesh with cpe210 antennas, correct cpe210 config?

< Deco

Need to extend a Deco m9+ mesh with cpe210 antennas, correct cpe210 config?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Need to extend a Deco m9+ mesh with cpe210 antennas, correct cpe210 config?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

22 Reply

LV1

2020-06-26 21:22:48

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-06-26

Re:Need to extend a Deco m9+ mesh with cpe210 antennas, correct cpe210 config?

2020-06-26 21:22:48

@Kevin_Z hi, I'm wondering whether this was resolved?

I would like to use Router > Deco M4 > CPE210 > CPE210 > Deco M4.

Is this possible?

0

0

#23

2021-06-10 03:53:19 - last edited 2021-06-10 03:53:45

Posts: 3599

Helpful: 1343

Solutions: 468

Stories: 0

Registered: 2020-06-30

Re:Need to extend a Deco m9+ mesh with cpe210 antennas, correct cpe210 config?-Solution

2021-06-10 03:53:19 - last edited 2021-06-10 03:53:45

Dear @JackBaxtech,

JackBaxtech wrote

hi, I'm wondering whether this was resolved?

I would like to use Router > Deco M4 > CPE210 > CPE210 > Deco M4.

Is this possible?

Yes, it's possible. The official firmware has been released to fix the problem, please check the firmware download link below:

https://www.tp-link.com/support/download/cpe210/#Firmware

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*

Recommended Solution

2

2

#24