Home Network Community > Accessories > Can't use internet after printer server set up
< Accessories

Can't use internet after printer server set up

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Can't use internet after printer server set up

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Can't use internet after printer server set up
Can't use internet after printer server set up
2013-01-12 06:18:01
Region : UnitedKingdom

Model : TL-WPS510U

Hardware Version : V3

Firmware Version :

ISP : O2

I've successfully installed and set up the TL-WPS510U, and the printer works fine.

But because I had to manually configure my IP address, I can't get on the internet. When I revert to "using DHCP" in the IP configuration, I can get on the internet but the printer server stops working.

Any assistance on this would be appreciated!

George
  0      
 
  0      
 
#1
Options
2 Reply
Re:Can't use internet after printer server set up
2013-01-12 18:31:39
The network type of the print server is Infrastructure? On your laptop, can you see WLAN_PS in the wireless network list?
  0  
  0  
#2
Options
Re:Can't use internet after printer server set up
2013-01-13 03:25:19
no i can't. i followed all the steps in the setup instructions on the website ( http://www.tp-link.com/en/article/?faqid=252). At step 2, I could see WLAN_PS on the network list, but now I can't.
Thanks for the reply.
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 510

Replies: 2

Related Articles
Can't complete initial set up
155 0
Can't set up connection alerts
4320 2
Can't Complete Set Up HS 210
561 0
set up
373 0
Set up
312 0
set up
271 0
About Us
Press
Copyright © TP-LINK CORPORATION PTE. LTD. All rights reserved.