Using Powerlines With Deco x20.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I am considering purchasing the Deco x20, but I am not sure if it can be used with the pre-existing power line adapters in my home. Here is a diagram of my ideal set up, will it work? Thanks!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Yes it should work,
I suggest you disable the wifi on the A7 and use it as a simple switch.
And make sure the link rate between the powerline adapters is as good as if you use the wireless backhaul between the Decos. Sometines it is not, depending of your electrical installation.
- Copy Link
- Report Inappropriate Content
Alright, thanks for the reply. There is a fair amount of concrete In between so I'll use the powerline just in case. Anyway I think the router will switch to the fastest config. I'll off the A7 wifi, when I set up the deco. Thxx
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Bobrovsky I use X20 - 3 pack. From Main, it is connected to one of the slave node via Power line 1GB. Once it is conencted, Deco App sees that link as Ethernet and automatically disable Wireless link.
- Copy Link
- Report Inappropriate Content
Olá, Tenho a mesma situação mas no caso gostava de saber se o ultimo Deco ligado através de powerline continua a emitir sinal wifi? Obrigado
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 4453
Replies: 5
Voters 0
No one has voted for it yet.