Change signal source manually

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2020-06-16 07:40:17

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-06-16

Change signal source manually

2020-06-16 07:40:17

Model: Deco M4

Hardware Version:

Firmware Version: 1.1.8

I've saw a few other posts about this subject and they all got the same answer: "we're working on it". Those posts were from 2019, other from 2020...

When will this feature be released? I really need it as I'm tired of rebooting the decos when it's choosing the wrong signal source again.

Thank you in advance!

1 Reply

LV1

2020-07-08 07:09:16

Posts: 13

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2020-07-08

Re:Change signal source manually

2020-07-08 07:09:16

@MaartenDeMoor You shouldn't need to config this manually if the mesh system actually works! But apparently it doesn't.