WR2543ND as Wireless Bridge

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

WR2543ND as Wireless Bridge

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WR2543ND as Wireless Bridge
WR2543ND as Wireless Bridge
2013-06-19 13:09:07
Region : UnitedKingdom

Model : TL-WR2543ND

Hardware Version : V1

Firmware Version :

ISP :


HI,

I'm not sure if I've bought the right device or not, trying to setup this router to act as a wireless bridge does anyone have an ideas?

I've changed IP address to match my network, enabled WDS bridging, attached to my wifi (status page say 'run' although it doesn't show up as a connected device on my BT hub 3?) switched off DCHP, PC connects via wire but doesn't see internet.
Paul
  0      
  0      
#1
Options
5 Reply
Re:WR2543ND as Wireless Bridge
2013-06-20 14:15:46
Hi,

WDS is delicate to set and doesn't work with all devices because there is no standard.
Do you use the same wireless channel?
Is the encryption and MAC filtering correct?
  0  
  0  
#2
Options
Re:WR2543ND as Wireless Bridge
2013-06-20 14:16:43
Does the BT hub also support WDS?As far as i knew,the TP-LINK WDS requires the main router also support the same WDS techinic. Otherwise, it will cause the compatible issue. Instruction for WDS http://www.tp-link.com/en/article/?faqid=227
  0  
  0  
#3
Options
Re:WR2543ND as Wireless Bridge
2013-06-20 15:31:26
Hit the nail on the head home hub 3 does not support WDS or at least you can't get to it. So in the market for another cable router I think that works well with BT fibre modem
  0  
  0  
#4
Options
Re:WR2543ND as Wireless Bridge
2013-06-21 15:57:59
Maybe a repeater or a range extender can meet your requirement with BT3.
  0  
  0  
#5
Options
Re:WR2543ND as Wireless Bridge
2013-06-22 20:12:02
Got tp-link gbit switch and power line transmitters
  0  
  0  
#6
Options