FEATURE REQUEST: Ability to separately enable/disable WiFi/PLC backhaul on Deco P9
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.FEATURE REQUEST: Ability to separately enable/disable WiFi/PLC backhaul on Deco P9
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
I recently bought 5 Deco P9 units to cover a large home. I was unpleasantly surprised to see that the devices prefer WiFi AND PLC backhaul by default (see attached image), even if a specific Deco device barely has a WiFi connection to the Main Deco. This results in very poor performance (150Mbit in the main deco unit plugged into the main router, 30Mbit in the secondary devices.)
This is highly disappointing, since the main reason I spent on these devices was for their promise of relying on PowerLine to distribute my Internet connection.
Is there a way to disable WiFi backhaul altogether? Please advise.
Thank you!
P.S.: I did tested the devices with different power plugs throughout the house, to no avail.
The Main Deco is plugged directly into a TP-Link Archer C6 (ethernet).
The Decos are configured in Access point mode, which should result in a star network set-up.
All the other Decos are plugged in throughout the house, in close enough proximity (as much as I've tried, I could not get them to be out of WiFi range from one another).
This problem seems related to https://community.tp-link.com/en/home/forum/topic/189518
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@TP-Link 1/2 Hello, all that information is available in my support ticket.
1. I've tried both modes - no difference
2. units closer to the main unit are obviously faster. However, there are thick walls in between, so some of the units have a worse signal and lower speed as a result.
3. I would like all satellites to only use Powerline backhaul - as that is the main reason I bought them for! I have previously tried other products and had the same result - the WiFi signal isn't strong enough due to the materials used in the walls
- Copy Link
- Report Inappropriate Content
the option to choose the signal source is in the ASUS ZenWiFi AX Hybrid XP4 .... TP-Link, please do this with the Deco P9 software
- Copy Link
- Report Inappropriate Content
@pawelb Thank you so much for that information! I'm tired of waiting on TP Link to listen to us. These are going on eBay after I purchase the Asus product you just linked to. I'll add it to my Amazon review to. Thanks!
- Copy Link
- Report Inappropriate Content
there is a fix for the Deco PLC issue, you just have to manually change the firmware. I posted a guide of how do it in the link below.
https://community.tp-link.com/en/home/forum/topic/175006?replyId=1002734
- Copy Link
- Report Inappropriate Content
Information
Helpful: 3
Views: 5212
Replies: 14
Voters 3
