Low outgoing signal

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Low outgoing signal
Low outgoing signal
2013-02-08 08:34:25
Region : Others

Model : TL-WR740N

Hardware Version : V4.20.0

Firmware Version :

ISP :


Hello,
I bought today new TP-Link TL-WR740N and I connected it with my cable modem as it is in manual instructed. There is problem with outgoing signal from router. It is about 1/10 from it should be (it is around 2Mbps from 20 Mbps). Same speeds are going out from router through LAN port and WiFI signal. Can anyone help me solve this problem? Thanks in advance
Thanks in advance.
0
0
#1
Options
6 Reply
Re:Low outgoing signal
2013-02-08 13:16:21
Post your test method and related screenshots.
Check the speed bypass WR740 and make a comparision.
To improve the speed, upgrade the firmware, reset it and reconfigure it.
0
0
#2
Options
Re:Low outgoing signal
2013-02-08 17:00:58
Also, download, install and run inssider to check whether or not there are other people in neighbouring houses who have WiFi routers using the same channel as yours. You may need to change your channel to one that is less congested.

http://www.metageek.net/products/inssider/
0
0
#3
Options
Re:Low outgoing signal
2013-02-13 07:55:56
I did all that you recommended, even my provider gave me new cable modem, but there is still same problem. Also I contacted tech support but they are on vacation due Chinese New Year. I am very confused about what could be wrong.
0
0
#4
Options
Re:Low outgoing signal
2013-02-13 08:46:52
Are you getting the expected speeds if you connect a computer directly to the cable modem?
0
0
#5
Options
Re:Low outgoing signal
2013-02-13 18:09:11
Yes, I am getting the expected speeds when I connect a computer directly to the cable modem.
0
0
#6
Options
Re:Low outgoing signal
2013-02-17 06:12:05
I solved problem. I rebooted few times router and few times restored factory defaults and it fixed.
0
0
#7
Options