Home Network CommunityMobile Wi-FiM7200 Band Selection for V1
Mobile Wi-Fi

M7200 Band Selection for V1

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

M7200 Band Selection for V1

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
M7200 Band Selection for V1
M7200 Band Selection for V1
2020-09-29 06:58:41 - last edited 2025-06-19 12:56:01
Model: M7200  
Hardware Version: V1
Firmware Version:

Is band selection option will be available also for V1 firmware of M7200? As per checking, it is already available for V2 firmware. Is there other way to select band without firmware update?

0
0
#1
1 Reply
Re:M7200 Band Selection for V1
2020-10-16 06:29:41 - last edited 2025-06-19 12:55:51

@JGC14 

Good day,

Thank you very much for your time and patience.

Sorry for the delay.

Band selection option is not available on V1 yet.

And as far as I know, V2 does not support either, so may I know where could you see the band selection option on the V2?

 

Thanks a lot.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
0
0
#2

Information

Helpful: 0

Views: 928

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.