Need to replace the cable that goes into the back of the router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Need to replace the cable that goes into the back of the router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Need to replace the cable that goes into the back of the router
Need to replace the cable that goes into the back of the router
2021-01-09 19:49:14
Model: Archer VR600  
Hardware Version: V3
Firmware Version:

Hello,

 

I have a Archer VR600 router and the cable that goes from my wall socket to my router that gives me internet has gone, 

I don't know what this cable is called but can someone let me know.

 

Thanks

 

Matthew

Matthew
  0      
  0      
#1
Options
2 Reply
Re:Need to replace the cable that goes into the back of the router
2021-01-09 20:04:59 - last edited 2021-01-09 20:14:38

@Matthew1 
 

If you used to connect to the grey port it's RJ11 cable (phone line cable)

If you used to connect to the yellow one it's RJ45 cable (Ethernet cable)

It depends on the service provider. If it is a broadband service, then RJ11 (phone line cable) to the grey port.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#2
Options
Re:Need to replace the cable that goes into the back of the router
2021-01-10 04:12:53
hola buenas nocheds tengo un router inalambrico lo configure y me da señal por unos minutos de ahi me saca y se desconecta es un tl-wr840n que mas puedo hacer para que este estable de la red y no me saque
  0  
  0  
#3
Options