MAC address filtering issue on Archer AX73.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello.
I bought new great wifi router - Archer AX73. But I have an issue with MAC address filtering (white list).
I did a simple test:
- enable MAC address filtering with white list option and add few devices to white list (devices which use wifi and cable),
- restart router, and after restart the only cable devices can connect to my network, all wifi devices are blocked.
The "solution" is: disable MAC address filtering and restart router again, but it is not acceptable solution.
Also adding new MAC address to the existed white list gives no effect. After add new device, restart is required with disabled MAC filtering, and then enable it again.
Kindly want to ask you - do you have similar problems with Archer AX73 router? I believe it is firmware issue, but not sure...
Regards,
Maciej
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hmmm... Japan version? :)
In the meanwhile, I installed beta firmware. I confirm: it resolves wifi issue.
But also noticed: wifi range is much worse than before (on official firmware)...
- Copy Link
- Report Inappropriate Content
EU inside ;)))
This is a new official firmware, it was just first posted for Japan. It's inside the EU with many languages, including Japanese. It gets up to the EU version normally. And the signal strength in this firmware is normal.
- Copy Link
- Report Inappropriate Content
Sure.
I installed today this firmware, and now everything is working fine.
Thanks for cooperation, I believe all our issues are resolved now :)
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 7861
Replies: 44
Voters 0
No one has voted for it yet.