Only 2 out of 3 are connected

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2021-03-02 13:00:14

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-03-02

Only 2 out of 3 are connected

2021-03-02 13:00:14

Model: Deco M5

Hardware Version: V3

Firmware Version: 1.5.2 Build 20210121 Rel. 55884

I have bought the 3pack DECO M5.

I have installed them as explained in the instruction video's.

Re-installed them, etc. But everytime only 2 out of 3 have a green light and the 3rd one has a red light (everytime another DECO unit).

So, it looks like it is not the unit that is broken, but somehow only 2 units can be used.

All 3 units are connected via cable to a switch and at this moment near each other (20 cm in between).

The one with the red light keep on telling me it can't be found by the others.

1 Reply

LV6

2021-03-02 14:23:57 - last edited 2021-03-02 14:24:12

Posts: 4081

Helpful: 2386

Solutions: 559

Stories: 0

Registered: 2020-10-22

Re:Only 2 out of 3 are connected

2021-03-02 14:23:57 - last edited 2021-03-02 14:24:12

Change Deco mesh Operating Mode to Access Point, for troubleshooting purposes, and see if suddenly all three Deco units are fine.