TP-Link settings for UnRAID SSL Certificate

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TP-Link settings for UnRAID SSL Certificate

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP-Link settings for UnRAID SSL Certificate
TP-Link settings for UnRAID SSL Certificate
2021-03-23 02:28:28
Model: Archer A8  
Hardware Version: V1
Firmware Version: 4.0.0 Build 20160517 Rel. 44603

I'm looking to provision a Let's Encrypt SSL Certificate for my unRaid server.  Unfortunately, I receive an error saying that "DNS Rebinding Protection" is engaged.  I've googled for solutions, but can't seem to find the exact spot where TP-Link's interface can change this.  Watching a YouTube video by Spaceinvader One, he manipulates his pfSense through the "DNS Resolver service."  I'm not sure if there is such a thing in the TP-Link interface.

 

Thanks for your time.

  0      
  0      
#1
Options
4 Reply
Re:TP-Link settings for UnRAID SSL Certificate
2021-07-04 04:56:47

@Salted11 

 

Hey, I am setting up my unraid server following spaceinvaderone's videos and ran into the same problem. Did you ever figure out a solution to this? Any help would be appreciated!!!

  0  
  0  
#2
Options
Re:TP-Link settings for UnRAID SSL Certificate
2021-07-05 13:51:50

@pjb1988 Unfortunately no.  I did get a response from tech support, but it was rather rudimentary (put in Google DNS).  I've asked this same question on other forums as well, and haven't gotten a reply.  I wonder if this is a tplink router issue, in that this obstruction is "baked into" the functionality of the router.  That, or I don't have a good enough understanding of how this stuff works!  (Hopefully the latter).  Best of luck, and if you find a solution, I'll be grateful.

  0  
  0  
#3
Options
Re:TP-Link settings for UnRAID SSL Certificate
2021-07-31 16:24:34

@Salted11 @pjb1988 hi both. I had the same problem and I was able to successfully provision by setting my Unraid DNS to 1.1.1.1 and 8.8.8.8 and then change the Deco DNS to the same. 

 

The DNS may not resolve immediately, it took a couple of minutes for me and then I was able to successfully provision.

 

Hope this helps.

  0  
  0  
#4
Options
Re:TP-Link settings for UnRAID SSL Certificate
2021-07-31 16:26:03

@opusdeath 

 

Thanks for the reply. I actually just attempted to do the same thing that didn't work again after posting this and it worked fine. Not sure why it worked one time and why it didn't the first time. 

  0  
  0  
#5
Options