Full-Sector DFS and EAP245s

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Full-Sector DFS and EAP245s

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Full-Sector DFS and EAP245s
Full-Sector DFS and EAP245s
2021-04-14 20:48:04

Have an installation of three EAP245s near a municipal airport that suffers from wireless interference.  Does "Full-Sector DFS" automatically work if the EAP245s are only hardwired? In this scenario the DSF selection box is not available. 

 

Will DSF work if the EAPs are hardwired and the Mesh and DSF boxes are selected and does the EAPs radio channel selection need to be on Auto for DFS to work? 

  0      
  0      
#1
Options
1 Reply
Re:Full-Sector DFS and EAP245s
2021-04-15 08:40:30

Dear @1207,

 

1207 wrote

Does "Full-Sector DFS" automatically work if the EAP245s are only hardwired? In this scenario the DSF selection box is not available. 

 

No, it only works for EAPs in the mesh network.

Here is the explanation to "Full-Sector DFS" in the UG of Omada Controller v4.2 for your reference:

 

 

Will DSF work if the EAPs are hardwired and the Mesh and DSF boxes are selected and does the EAPs radio channel selection need to be on Auto for DFS to work? 

 

At present, EAP245 with US/CA version doesn't support DFS channels. If your EAP245 is EU version, you could leave the channel as Auto(the device will detect and select a clean channel when it's rebooted), or select a DFS channel manually.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  1  
  1  
#2
Options

Information

Helpful: 0

Views: 1333

Replies: 1

Related Articles