One Mesh is Supported in Access Point Mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

One Mesh is Supported in Access Point Mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
One Mesh is Supported in Access Point Mode
One Mesh is Supported in Access Point Mode
2021-05-05 17:00:15 - last edited 2021-05-06 02:59:21
Model: Archer AX20  
Hardware Version: V1
Firmware Version: 1.2.0 Build 20201023 rel.69987(5553)

Model : TP Link Archer AX20 v1.20 AX1800 Wi-Fi 6 Router

 

I upgraded the firmware to 1.2.0 Build 20201023 rel.69987(5553) which claimed support for OneMesh. But since the Router was in 'Access Point Mode', OneMesh was not getting enabled. 

 

After I changed the mode to 'Wireless Router Mode', only then the OneMesh was getting enabled?  Is it that in access point mode, OneMesh is not supported?

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:One Mesh is Supported in Access Point Mode-Solution
2021-05-06 00:11:03 - last edited 2021-05-06 02:59:21

@mvsiva 

 

Yes, it is. Check this FAQ - Q8/A8.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  1  
  1  
#2
Options
2 Reply
Re:One Mesh is Supported in Access Point Mode-Solution
2021-05-06 00:11:03 - last edited 2021-05-06 02:59:21

@mvsiva 

 

Yes, it is. Check this FAQ - Q8/A8.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  1  
  1  
#2
Options
Re:One Mesh is Supported in Access Point Mode
2021-05-06 02:40:20

@terziyski  Thank you for the information 

  0  
  0  
#3
Options