Change of ISP can’t get my extender to recognise the new one

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Change of ISP can’t get my extender to recognise the new one

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Change of ISP can’t get my extender to recognise the new one
Change of ISP can’t get my extender to recognise the new one
2021-07-18 13:48:17
Model: TL-WA850RE  
Hardware Version: V7
Firmware Version:

I recently changed my ISP and have a new router. I have tried a hard reset on the wireless adapter and have also connected it directly to the new router via Ethernet. Yet when I try to connect it still shows the name of my old router and will not accept the password of the new one. 
 

how can I get it to recognise my new router
 

 

  0      
  0      
#1
Options
1 Reply
Re:Change of ISP can’t get my extender to recognise the new one
2021-07-21 19:50:24 - last edited 2021-07-21 19:56:17

@Poodle 

 

Reset the extender to factory defaults:

Then go to Chapter 2 of your user guide to reconfigure the extender from scratch, connecting it to the new router.

Ethernet port is used when you configure the device in AP mode or as a wireless adapter.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 292

Replies: 1