Home Network Community > Wi-Fi Routers > 5ghz on Onemesh is extremely unstable, cuts out every 5 minutes.
< Wi-Fi Routers

5ghz on Onemesh is extremely unstable, cuts out every 5 minutes.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

5ghz on Onemesh is extremely unstable, cuts out every 5 minutes.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
5ghz on Onemesh is extremely unstable, cuts out every 5 minutes.
5ghz on Onemesh is extremely unstable, cuts out every 5 minutes.
2021-07-19 22:39:04
Model: Archer A6  
Hardware Version: V2
Firmware Version: 1.1.8 build 20210226

So I have an Archer A6 with firmware version 1.1.1.8 build 20210226. 

Connected to this is two RE220 extenders with Onemesh on. For some reason the 5ghz is just completely unstable, it cuts out every few minutes. The 2.4 is perfect though and causes no trouble. I actually have about 6 re220's around but I found that if you try to connect one to another , no matter how close, the red 5ghz light kicks on the most recently connected almost immediately and then signal goes haywire. Shouldn't you be able to connect one to the other in a mesh system?

  0      
 
  0      
 
#1
Options
1 Reply
Re:5ghz on Onemesh is extremely unstable, cuts out every 5 minutes.
2021-07-19 23:08:33

@Lwilburn2 

 

You can refer to this description of OneMesh - Q4/A4.

Since 5 GHz band is more susceptible to distance try moving repeaters closer to the router to see if that will improve the signal.

 

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 441

Replies: 1

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.