Home Network Community > Access Points > How do you use a 702N as a bridge ?
< Access Points

How do you use a 702N as a bridge ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How do you use a 702N as a bridge ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How do you use a 702N as a bridge ?
How do you use a 702N as a bridge ?
2021-08-19 17:34:33 - last edited 2021-09-13 03:46:48

Can someone explain clearly how you do this ? Do I need to change the ip adress to a fixed one in ipv4 or can I leave it as find automatically ?

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:How do you use a 702N as a bridge ?-Solution
2021-08-20 16:55:14 - last edited 2021-09-13 03:46:48

@m1ctk 

 

Use this guide to configure 702N in bridge mode.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:How do you use a 702N as a bridge ?-Solution
2021-08-20 16:55:14 - last edited 2021-09-13 03:46:48

@m1ctk 

 

Use this guide to configure 702N in bridge mode.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 409

Replies: 1

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.