Home Network Community > Wi-Fi Routers > Wireless WDS Setup problem
< Wi-Fi Routers

Wireless WDS Setup problem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wireless WDS Setup problem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wireless WDS Setup problem
Wireless WDS Setup problem
2021-09-01 00:01:56 - last edited 2021-09-02 11:54:39
Model: TL-WR940N  
Hardware Version: V3
Firmware Version:

Hello. I just bought my new router Archer AX73 and now am trying to setup wireless(wi-fi) WDS Bridge. 
I turn off  DHCP, WPS, but my router still didn't give any internet.

  0      
 
  0      
 
#1
Options
1 Reply
Re:Wireless WDS Setup problem
2021-09-01 21:05:02 - last edited 2021-09-02 11:54:39

@YulianNYC 

 

If you're trying to configure WDS on TL-WR940N v3 use this guide. After finishing the configuration reboot the device and test.

You can go to Status > Wireless to check the WDS status. When the WDS status is Run, it means WDS bridging is successfully built.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 436

Replies: 1

Related Articles
Archer A6 WDS setup
5081 0
Problems with WDS
2494 1
Archer C80 WDS Problem - verliert Verbindung
506 0
Wireless AP setup problem
315 0
Archer C6 v2: 5Ghz WDS Bridging Setup Grayed!
2840 0
WDS setup
551 0
About Us
Press
Copyright © TP-LINK CORPORATION PTE. LTD. All rights reserved.