WRD3600 USB storage not acessible
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WRD3600 USB storage not acessible
Region : Australia
Model : TL-WDR4300
Hardware Version : V1
Firmware Version :
ISP :
I'm having difficullty configuring a USB hard drive to my WDR3600
The WRD3600 is acting as a switch with my netgear cable modem router as the DHCP server. The DHCP server on the WRD3600 is turned off. the WRD3600 is accessible on my home network and I can connect to attached wifi and Ethernet devices.
when I attach my WD USB hard drive, I can see the device on the WDR3600 web GUI USB settings page. The WD hard drive service status is started and enabled. when I click on the open the disk link, nothing happens. When I try to access the 192.168.x.x/volume1 address, I get a page that says the username or password is incorrect.
When I disconnect the WDR3600 from the rest of my network and turn the DHCP server back on and connect directly to the router, i am able to access the connected usb hard drive.
is it possible to have the WDR3600 acting as a switch with DHCP server off and still access usb devices connected to it?
thanks.
Model : TL-WDR4300
Hardware Version : V1
Firmware Version :
ISP :
I'm having difficullty configuring a USB hard drive to my WDR3600
The WRD3600 is acting as a switch with my netgear cable modem router as the DHCP server. The DHCP server on the WRD3600 is turned off. the WRD3600 is accessible on my home network and I can connect to attached wifi and Ethernet devices.
when I attach my WD USB hard drive, I can see the device on the WDR3600 web GUI USB settings page. The WD hard drive service status is started and enabled. when I click on the open the disk link, nothing happens. When I try to access the 192.168.x.x/volume1 address, I get a page that says the username or password is incorrect.
When I disconnect the WDR3600 from the rest of my network and turn the DHCP server back on and connect directly to the router, i am able to access the connected usb hard drive.
is it possible to have the WDR3600 acting as a switch with DHCP server off and still access usb devices connected to it?
thanks.