TL-WR941ND bridges, connects PC/ipad but not Galaxy S2
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-WR941ND bridges, connects PC/ipad but not Galaxy S2
Region : Others
Model : TL-WR941ND
Hardware Version : Not Clear
Firmware Version : 3.13.9 Build 120201 Rel.54965n
ISP : Ezecom
My TL-WR941ND wireless router bridges to either of two other routers (in adjacent apartments), one of which is connected by cable to the ISP.
This router also connects to each of my ipad 2, laptop and Galaxy S2 (Android 4.1.2) phone.
However, only the ipad and laptop can access internet via this setup. The Android phone cannot.
All three of the devices (Android, laptop, ipad) can access internet by connecting to either of the other two routers in the bridge. But the signal to these is not so strong.
I cannot work out why the Android cannot connect to internet via the TP-Link.
I'm a novice at best when it comes to wireless routers and the like but I can at least get to the router control panel and make changes or check settings there if needed. Any suggestions as to what to look for in diagnosing this?
Note: Hardware version: "v2/v3"
Model : TL-WR941ND
Hardware Version : Not Clear
Firmware Version : 3.13.9 Build 120201 Rel.54965n
ISP : Ezecom
My TL-WR941ND wireless router bridges to either of two other routers (in adjacent apartments), one of which is connected by cable to the ISP.
This router also connects to each of my ipad 2, laptop and Galaxy S2 (Android 4.1.2) phone.
However, only the ipad and laptop can access internet via this setup. The Android phone cannot.
All three of the devices (Android, laptop, ipad) can access internet by connecting to either of the other two routers in the bridge. But the signal to these is not so strong.
I cannot work out why the Android cannot connect to internet via the TP-Link.
I'm a novice at best when it comes to wireless routers and the like but I can at least get to the router control panel and make changes or check settings there if needed. Any suggestions as to what to look for in diagnosing this?
Note: Hardware version: "v2/v3"