Home Network Community

Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > M4R slave cap at 100Mbps

< Deco

M4R slave cap at 100Mbps

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

M4R slave cap at 100Mbps

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Quocvu

LV1

2021-10-10 03:28:34

Posts: 6

Helpful: 7

Solutions: 0

Stories: 0

Registered: 2021-10-10

M4R slave cap at 100Mbps

2021-10-10 03:28:34

Model: Deco M4

Hardware Version: V2

Firmware Version: 1.4.3 Build 20200918 rel 74289

Brand new M4 master unit get 200Mbps is maximum from ISP. But on the 2nd unit (wired to the master) is always cap at 100Mbps?

if you need any information I will provide later.

1 Reply

terziyski

LV7

2021-10-11 09:59:24

Posts: 6104

Helpful: 4308

Solutions: 886

Stories: 7

Registered: 2013-10-12

Re:M4R slave cap at 100Mbps

2021-10-11 09:59:24

@Quocvu

Plug the ethernet cable in the other ethernet port (on satellite Deco).

If the issue persists then change the cable (a quality Cat 5E/6 cable is required).

This usually happens when the negotiated speed is not 1000mbps, but only 100mbps.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".

Quocvu

LV1

2021-10-10 03:28:34

Posts: 6

Helpful: 7

Solutions: 0

Stories: 0

Registered: 2021-10-10

Information

Helpful: 0

Replies: 1

M4R slave cap at 100Mbps

M4R slave cap at 100Mbps

Information

Voters 0

Tags