Share internet with hotspot
Hi guys,
I need your help. Basically I moved home and I have more than 25 wifi devices and the temporary solution from ISP (hotspot) only allow 10 connections.
The workaround that I'm trying to do is:
1) Hotspot with wifi SSID xxxG and I only access with 3/4 important devices including the PC.
2) On PC I get inside that xxxG network (192.168.0.1) and Share Internet Connection via Ethernet adapter to the WAN port on the Archer C20.
2.1) The ethernet have static ip of 192.168.137.1
3) On Archer settings I have this:
Mode: Access Point
Wireless 2,4Ghz
SSID: xxxA
LAN
MAC Address: XXX
IP Address: 192.168.137.1
Subnet Mask: 255.255.255.0
DHCP Settings
DHCP Server: Enable
Start IP Address: 192.168.137.100
End IP Address: 192.168.137.199
Address Lease Time: 60 minutes
Default Gateway: 192.168.137.1
Default Domain: tplinkwifi.net
DNS Server: 8.8.8.8
Secondary DNS Server: 8.8.4.4
All devices enter xxxA perfectly and get IP but no internet connection. I tried to set auto IP on the Ethernet adapter but doing that with the same subnet it will drain the 10 devices and not creating a new set of devices like it's needed.
Advise please?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I changed to this and started working! .....
Ethernet adapter
IPv4 Address. . . . . . . . . . . : 192.168.137.2(Preferred)
Subnet Mask . . . . . . . . . . . : 255.255.255.0
Default Gateway . . . . . . . . . : 192.168.137.1
Basically it's working with the "quick setup" and Static IP 192.168.137.1.
Shared Internet via adapter and placed that adapter with the setup above...
- Copy Link
- Report Inappropriate Content
Configure A2 in AP mode following this guide (case 1). DHCP service on the router in AP mode should be disabled.
Set your router's WAN (blue) port to Dynamic IP, then connect the ethernet port of your PC to the WAN(blue) port of the router.
The ICS service on your PC provides DHCP and NAT service to your router and you should have an Internet access on devices connected to the router.
If you have difficulties configuring ICS on your PC follow this thread.
- Copy Link
- Report Inappropriate Content
@terziyski I tried that in a million ways but still have no internet connection. I traded it for a tp-wa801n bit it haven't made it possible...
Any advise on share computer internet? I need to get it via WiFi and share via wan to the router so I can make a new wifi network with lot more than 10 devices
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@terziyski I did like the main post I placed, the only difference now is that I'm using the TL-WA801N.
Same settings with AP enabled and still can't get internet... Is there any way to test if my pc is really providing internet to router?
- Copy Link
- Report Inappropriate Content
Should be the same configuration with TL-WA801N in AP mode.
Observe the the ethernet port configuration when set as Smart IP(DHCP).
It should receive an IP address in 192.168.137.0/24 subnet if you've configured the ICS properly.
- Copy Link
- Report Inappropriate Content
@terziyski Still don't work, now I can't resolve IP and connect at all..
I have set like AP with Static IP because otherwise I could not set to 192.168.137.1 (router have 192.168.0.1), SmartIP was with 192.168.0.254 and DHCP was not possible to disable..
After that, can't connect... any advise?
My ethernet usb adapter have IP 192.168.137.1
Ethernet adapter Ethernet:
Connection-specific DNS Suffix . :
Description . . . . . . . . . . . : Realtek USB GbE Family Controller
Physical Address. . . . . . . . . : XXX
DHCP Enabled. . . . . . . . . . . : No
Autoconfiguration Enabled . . . . : Yes
Link-local IPv6 Address . . . . . : XXX(Preferred)
Autoconfiguration IPv4 Address. . : 169.254.143.53(Preferred)
Subnet Mask . . . . . . . . . . . : 255.255.0.0
IPv4 Address. . . . . . . . . . . : 192.168.137.1(Duplicate)
Subnet Mask . . . . . . . . . . . : 255.255.255.0
Default Gateway . . . . . . . . . :
DHCPv6 IAID . . . . . . . . . . . : 295496680
DHCPv6 Client DUID. . . . . . . . : XXX
DNS Servers . . . . . . . . . . . : 8.8.8.8
8.8.4.4
NetBIOS over Tcpip. . . . . . . . : Enabled
Wireless LAN adapter Wi-Fi:
Connection-specific DNS Suffix . :
Description . . . . . . . . . . . : Intel(R) Dual Band Wireless-AC 7265
Physical Address. . . . . . . . . : XXX
DHCP Enabled. . . . . . . . . . . : Yes
Autoconfiguration Enabled . . . . : Yes
Link-local IPv6 Address . . . . . : XXX(Preferred)
IPv4 Address. . . . . . . . . . . : 192.168.0.26(Preferred)
Subnet Mask . . . . . . . . . . . : 255.255.255.0
Lease Obtained. . . . . . . . . . : 6 de dezembro de 2021 16:13:04
Lease Expires . . . . . . . . . . : 7 de dezembro de 2021 16:13:05
Default Gateway . . . . . . . . . : 192.168.0.1
DHCP Server . . . . . . . . . . . : 192.168.0.1
DHCPv6 IAID . . . . . . . . . . . : 122176800
DHCPv6 Client DUID. . . . . . . . : XXX
DNS Servers . . . . . . . . . . . : 192.168.0.1
NetBIOS over Tcpip. . . . . . . . : Enabled
ROUTER IS 192.168.0.1 - from 192.168.0.2 to 192.168.0.100
- Copy Link
- Report Inappropriate Content
I changed to this and started working! .....
Ethernet adapter
IPv4 Address. . . . . . . . . . . : 192.168.137.2(Preferred)
Subnet Mask . . . . . . . . . . . : 255.255.255.0
Default Gateway . . . . . . . . . : 192.168.137.1
Basically it's working with the "quick setup" and Static IP 192.168.137.1.
Shared Internet via adapter and placed that adapter with the setup above...
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1081
Replies: 7
Voters 0
No one has voted for it yet.