2 RE 300s with same name?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.2 RE 300s with same name?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have 2 RE 300 range extenders running off my router, which is on the secnd floor. One extender is on the third floor, and one is on the first floor, but after setup I realize they both have the same name, i.e., Routername_EXT. Seem to have separate MAC addresses though, as I look at the Tether app.
Should I give them different names to make sure my devices from the first floor aren't trying to connect with the extender on 3 (and vice versa), or is it good to keep the same EXT name so when I go from floor 3 to floor 1 devices autmatically "switch" to the nearest extender (if that's possible)?
Hope that all makes sense. Thanks for any ideas.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@TJE333 If everything went well then you can use yes, there's no secret in the configuration. I believe you did it correctly.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@TJE333 no, this is the configuration, you did it right. Well that's it, just call anything.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1450
Replies: 13
Voters 0
No one has voted for it yet.