Firewall problem on Archer C80
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello
Recently, i installed Archer C80 router behind an operator box in order to stabilize and extend the very poor wifi coverage upstairs.
So, on the operator box side:
Lan: 192.168.1.0/24
Gateway:192.168.1.1
Dmz:192.168.1.254
Router:
Router Mode
Lan: 192.168.2.0/24
Gateway: 192.168.2.1
Ip Wan: 192.168.1.254
Dhcp: 192.168.2.10 to 192.168.2.50
The wifi performances are excellent and the clients on the router side communicate except that the printer (192.168.2.11) in wifi cannot be reached on a PC (box side), ping NOK on the addresses 192.168.2.X
On this PC, i declared a static route in 192.168.2.0 gateway 192.168.1.254 but NOK.
Then, I noticed that, with "SPI Firewall" deactivated, the network on the router side was reachable on the pc (box side).
But, the firewall does not have enough settings on this router, which rule or other settings creates in the routing table to avoid disabling SPI Firewall.
