Home Network Community > Wi-Fi Routers > Repeater mode screw with the default gateway causing problems
< Wi-Fi Routers

Repeater mode screw with the default gateway causing problems

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Repeater mode screw with the default gateway causing problems

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Repeater mode screw with the default gateway causing problems
Repeater mode screw with the default gateway causing problems
2022-01-20 01:34:22 - last edited 2022-01-21 22:50:48
Model: TL-WR841HP  
Hardware Version: V3
Firmware Version: 3.16.9 Build 161108 Rel.67995n

Im trying to use the repeater mode but every time the conection on my pc shows problems and it says the default gateway is not avaible, and i don't know what to do  

  0      
 
  0      
 
#1
Options
4 Reply
Re:Repeater mode screw with the default gateway causing problems
2022-01-20 21:35:33

@L108 

 

Here's a guide how to configure the device in range extender mode. Video guide is available as well.

When you're ready to place your TL-WR841HP make sure it's not too far from your main router.

Here's a practical guide on how to properly place a range extender.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#2
Options
Re:Repeater mode screw with the default gateway causing problems
2022-01-21 02:57:34

@terziyski I did all that but it continues the same

 

  0  
  0  
#3
Options
Re:Repeater mode screw with the default gateway causing problems
2022-01-21 09:19:04 - last edited 2022-01-21 10:27:10

@L108 

 

If you post some more details about your network infrastructure like:

1. Do you have any ISP modem/router besides your main router

2. What's your main router made and model

3. What's your main router LAN IP address

4. Screenshot of the WR841HP status page:

5. A screenshot of the error in question would be helpful too.

 

it would be easier to pin-point the issue.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#4
Options
Re:Repeater mode screw with the default gateway causing problems
2022-01-21 22:35:14

@terziyski when i put it in repeater mode i can no longer acess the config pages of both devices (the WR841HP and the modem/main router

  0  
  0  
#5
Options

Information

Helpful: 0

Views: 1015

Replies: 4

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.