Archer AX1000
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer AX1000
The 2.4ghz signal is completely gone
I did a firmware update about a week ago and have not been able to connect to the channel since then.
how do I fix this?
Re:Archer AX1000
Make sure that your 2.4GHz band is enabled and broadcating a signal - can you see its SSID in the list of available networks.
If you can see its SSID, change your password to be sure you entering the correct one, forget the network from the known networks and re-add it again.
If nothing helps so far reset to factory defaults and re-configure the router from scratch:
Here's a guide on how improve you wireless speed and coverage.
If this was helpful click on the arrow pointing upward to make it blue.
If this solves your issue, click the star to make it blue as a "Recommended Solution".
Tips:149wubkkfoLmNDjDbiTxx4ZU8mpcMA5CJt