Ingress rate limit reduces speed to wrong value
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
hi!
I have aTL-SG3428MP managed over an OC200 Controller.
For Port 4 on this switch I have set the following limits:
Egress Rate Limit: 120Mbps
Ingress Rate Limit: 5 Mbps
I tested this with a laptop connected to the port 4 and made a speed test.
Without limits set:
Download: 200 Mbps
Upload: 20 Mbps
That's fine, because that is the bandwith from my ISP.
With limits set:
Download: 118 Mbps
Upload: 2,3 Mbps
With limits set and ingress rate changed to 10 Mbps:
Download: 118 Mbps
Upload: 2,5 Mbps
With limits set but ingress rate removed:
Download: 118 Mbps
Upload: 20 Mbps
Do I understand this limits wrong or is there a bug in the firmware?
I want to have 5 Mbps Upload (ingress) for this port and thought this would be the right setting!?
Regards
Alex
