access internet via offsite proxy or VPN server
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.access internet via offsite proxy or VPN server
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have a Omada controlled site and need specific devices to access internet web services via an offsite proxy or offsite VPN server.
These specific devices can be identified either by a VLAN, subnet, IP or MAC and are labeled "A" and "B" in the network diagram below.
I can configure each device to access internet web services via the proxy or the VPN server and it works. But how it should work is that the traffic of these devices is redirected automatically to the proxy or VPN without a configuration on these devices need.
I could not figure out how to set this up in the omada suite. Help is greately appreciated! Thanks a lot in advance!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I too tried to move my default LAN off 192.168.0.0/24, but it caused me nothing but headaches, so I gave up fighting it and just let it happen. I don't think that's your issue though.
First we need to get your tunnel established, then worry about the rest (I had assumed this was functional). I have two suggestions, the first is to reduce the MTU on your router WAN interface to 1460 from 1500 and the second is to temporarily disable encryption on the L2TP tunnel (you may have to change settings at the server end as well to do this).
Try these and if you get your tunnel established, the rest should 'just work'. Viel Glück.
- Copy Link
- Report Inappropriate Content
The only way to configure the LAN ports of the router is by using the web-based interface. You can access the web-based interface by going to the router's IP address in a web browser.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 3231
Replies: 12
Voters 0
No one has voted for it yet.