EAP115 remains at status Provisioning in EAP Controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP115 remains at status Provisioning in EAP Controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP115 remains at status Provisioning in EAP Controller
EAP115 remains at status Provisioning in EAP Controller
2022-05-09 13:33:35
Model: EAP115  
Hardware Version: V4
Firmware Version: 5.0.2 Build 20210604 Rel. 50960

Hello,

I'm trying to add a EAP115 to an EAP Controller but it always remains at status Provisioning.

I have tried to forget the AP in the controller and reset the EAP115 in the web UI of the AP. Also tried to reset it with the physical reset button.

But every time I try to add the EAP115, it only goes until Provisioning...

I already have 4 other EAPs in the controller - they work fine (2 of them are EAP115 but with Firmware 3.3.0)

 

The EAP Controller is Version: 2.4.8

 

What am i doing wrong?

 

Best regards

  2      
  2      
#1
Options
2 Reply
Re:EAP115 remains at status Provisioning in EAP Controller
2022-05-09 15:26:09

  @Skora 

 

I don't think your v5.x AP firmware plays  nicely with v2.x controller software (they changed the omada ports and some of the autoconfig dance in going to v5).

 

If you cannot downgrade your AP, then you should look to update your controller and everything else...if only to patch security vulnerabilities like the log4j one.

<< Paying it forward, one juicy problem at a time... >>
  2  
  2  
#2
Options
Re:EAP115 remains at status Provisioning in EAP Controller
2022-05-10 06:50:00

  @d0ugmac1 

thanks! I downgraded the AP and could add it to the controller then. Now that I know that the AP is not defect, I ordered an OC200. You are right, it was time for an upgrade instead of a downgrade :D

  0  
  0  
#3
Options