M7200 does not turn on

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

M7200 does not turn on

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
M7200 does not turn on
M7200 does not turn on
2022-05-27 14:29:17 - last edited 2022-05-27 14:37:52
Model: M7200  
Hardware Version: V3
Firmware Version: 211117

 

Hello,

 
let's get straight to the point, when I turn on the router or connect it to the network, all three lights light up, and the Internet does not work, resetting the settings also does not work, and if I remove the battery, everything is the same. I tried to wait but it still not worked.


Help me please!
  5      
  5      
#1
Options
3 Reply
Re:M7200 does not turn on
2022-05-30 08:19:21

  @butek 

 

Hi, thank you very much for the feedback.

Do you mean all the three LEDs stay on and never turn off? when pressing and holding the reset hole with a pin, there is no any response?

 

Are you able to see and connect the TP-Link WiFi? and was the M7200 working fine before?

 

If you are able to see and connect the WiFi but no internet access, please do some troubleshooting as the following instruction:
https://www.tp-link.com/support/faq/794/

 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options
Re:M7200 does not turn on
2022-05-30 13:35:25

  @Sunshine 

1. Yes, all the three LEDs stay on and never turn off. 2. No, there is no any response when I'm pressing and holding the reset hole. 3. No, i don't able to see and connect to the WiFi. 4. Yes, the M7200 was working fine before.

  0  
  0  
#4
Options
Re:M7200 does not turn on
2022-05-31 01:34:05

  @butek 

 

Hi, thank you very much for the reply.

It seems that the M7200 is defective since there is no any response when resetting it. It is recommended to contact the seller where you bought it to check warranty and get it replaced. Really sorry for any inconvenience caused!

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#5
Options

Information

Helpful: 5

Views: 1390

Replies: 3

Related Articles