Archer C2 remote web, shows 403 forbidden

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2022-07-04 09:28:18

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-07-04

Archer C2 remote web, shows 403 forbidden

2022-07-04 09:28:18

Model: Archer A2

Hardware Version: V1

Firmware Version: 170207

I have set up remote management, but it says "403 forbidden"

As I have not logged out of the router session, it tells me to log out, when I log out it shows me 403 forbidden again.

I tried different ports, browsers, devices, but it doesn't work.

If you can help?

1 Reply

LV7

2022-07-05 22:42:47 - last edited 2022-07-06 00:38:27

Posts: 7029

Helpful: 5235

Solutions: 1162

Stories: 7

Registered: 2013-10-12

Re:Archer C2 remote web, shows 403 forbidden

2022-07-05 22:42:47 - last edited 2022-07-06 00:38:27

Go through this thread and check the suggested solutions.

If you're trying to access C2 via remote network try to use its WAN IP address (it should be a public IP address) instead a DDNS (if you use one).

If none of the suggested actions helps then you can contact your local support for assistance.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".