Speed loss with Deco s4 and virgin hub 3
Hi, need help with finding choke point on new Deco s4 mesh.
Virgin hub 3 with 350 mbps (tested with ookla beforehand) in modem mode, Deco in router mode. Speed test from main Deco is only +- 70 mbps, several tests same result.
Could the choke point be the supplied cable?
Thanks.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Could be the cable, that should be easy to check if you replace it by the different cable.
Also check if you do have Deco S4 and not Deco E4 by any chance. Deco E4 has 100Mbit Ethernet ports and will deliver about the speeds you do see. If you are not sure, attach wired device such as laptop, with gigabit Ethernet card, to second Ethernet port of Main Deco. If laptop negotiates Ethernet link of only 100Mbps, that is where the problem is.
See this FAQ, it may be helpful: Using QoS feature of Deco
Turn off 2.4GHz in Deco app, for Deco Main Network, and run speed tests again with just WiFi5:
- Copy Link
- Report Inappropriate Content
Cable check turns out I used another anyway (Cat 5) so that's not the issue.
S4 packaging and S4 on underside of pods, so pretty sure they're S4's unless they have been rebranded!
Tried turning off 2.4, same results.
Always 60-70.
Checked internet connection speed, 433mbps.
QoS set at 400 up 400 down.
Running out of ideas, your help is much appreciated.
- Copy Link
- Report Inappropriate Content
to add, having seen other similar posts this seems to be a regular problem with Deco S4s only managing 60-70 mbps with Virgin hub in modem mode.
This negates the original reason for purchasing the Decos as I live in an old house and needed the extra reach of the mesh.
The network seems to work just fine with good signal all over, it just never gets the speeds that I pay Virgin for.
There must be a specific problem if every time I speed check I get the exact same results (60-70).
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
The only other thing left to try is rollback Hub to gateway mode, and configure Deco mesh to run in Access Point mode. How to set up Deco to work in Access Point mode
Then, try running speed tests again, with 2.4GHz turned off.
If that does not help, then it makes sense to return Deco and try WiFi mesh from the different brand.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 914
Replies: 7
Voters 0
No one has voted for it yet.