Deco x20 setting

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco x20 setting

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco x20 setting
Deco x20 setting
2022-09-16 02:12:37
Model: Deco X20  
Hardware Version:
Firmware Version:

Hi,

 

I set up the deco x20 and did a speed test. Apparently, the speed on the deco router is not going beyond 100 Mbps. When I connect my device to the main router and the speed is averaging 400-500 Mbps. As soon as I switch it to the deco router, the speed drop below 100 Mbps, and the average is around 80-90 Mbps when I am near the deco router, if I go further away from the deco router it drops furthermore to 45 Mbps. 

 

Is there any setting that I need to do to help boost the speed up?

 

Thanks

Mike

  0      
  0      
#1
Options
2 Reply
Re:Deco x20 setting
2022-09-16 13:23:32 - last edited 2022-09-16 14:25:35

  @Mike-Chen 

 

There could be settings in Deco responsible for throttling traffic, but other scenario also possible: Deco pushes your device to slower 2.4GHz or Main Deco negotiated 100Mbps wired link with the router.

 

To eliminate Deco settings as a cause, make the following two changes:

 

1. Configure Deco mesh to run in Access Point mode. How to set up Deco to work in Access Point mode

2. Turn off 2.4GHz on Main network in Deco app:

 

Then, run your speed tests again. If all you get is under 100Mbps, that strongly points at Ethernet cable between Main Deco and router, forcing Deco negotiate 100Mbps instead of gigabit.

  1  
  1  
#2
Options
Re:Deco x20 setting
2022-09-16 16:59:16

Thanks for your help

  0  
  0  
#3
Options