Wan ip binding

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wan ip binding

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wan ip binding
Wan ip binding
2022-10-19 10:19:03
Tags: #DDNS

Hello, I have a archer AX20, when trying to set up DDNS there is an option for Wan ip binding. What does this toggle do? 

 

  1      
  1      
#1
Options
2 Reply
Re:Wan ip binding
2022-10-19 16:11:19 - last edited 2022-10-19 16:26:55

  @TwoEyedJack 

 

This option binds the WAN IP address on the status page in router's web management interface to the DDNS record.

If the AX20 WAN IP address is a private IP address (whether dynamic or static), it's not recommended to turn this option ON.

Private IP addresses are in these ranges:

  • Range from 10.0.0.0 to 10.255.255.255 — a 10.0.0.0 network with a 255.0.0.0 or /8 (an 8-bit) mask
  • Range from 172.16.0.0 to 172.31.255.255 — a 172.16.0.0 network with a 255.240.0.0 or /12
  • A 192.168.0.0 to 192.168.255.255 range, which is a 192.168.0.0 network masked by 255.255.0.0 or /16
  • A special range 100.64.0.0 to 100.127.255.255 with a 255.192.0.0 or /10 network mask; this subnet is recommended according to rfc6598 for use as an address pool for CGN (Carrier-Grade NAT)
If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options
Re:Wan ip binding
2022-10-19 16:21:12

  @terziyski 

 

My Wan ip is dynamic. So what would this option be used for then? Does it matter if I have it on or off? 

  1  
  1  
#3
Options

Information

Helpful: 1

Views: 1496

Replies: 2

Tags

Related Articles