Differences in EAP225 v4 and v5 in Omada Controller
Hoping you can help.....
I have two EAP225s but different hardware versions e.g. v4 and v5
My Version 4 is running:
5.0.8 Build 20220613 Rel. 51936
My Version 5 is running:
1.0.0 Build 20220713 Rel. 63370
When looking at both of these devices via my OC200 v2 5.6.4 - 2.6.1 Build 20220921 Rel.35903
I see the following differences:
V4
V5
On the Dashboard for Retried and Drop Rate:
V4 Looks too good when compared to V5. EAP225-S is V4 and EAP225-B is V5.
V4 Retried:
V4 Dropped:
V5 Retried:
V5 Dropped:
It would seem the V5 vs V4 measurements are more granular. I cannot explain why the device info for V5 is showing Busy & Free and the V4 is showing RX/TX Frames, Interference and Free.
Could you advise and say if there are any plans for newer Firmware releases for these EAP devices that would harmonise their appearance in the Omada Controller please?