Luz de iniciação não fixa

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Luz de iniciação não fixa

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Luz de iniciação não fixa
Luz de iniciação não fixa
2023-06-05 06:26:22
Model: RE450  
Hardware Version:
Firmware Version:

Bom dia 

 

O meu repetidor de sinal desliga, sozinho sem estar configurado para isso e quando o tento voltar a ligar, a luz não fixa, permanecendo sempre a piscar até voltar a desligar por si. 

 

Só o consigo voltar a ligar quando após algumas vezes, desligo e volto a ligar na corrente o router da operadora contratada, neste caso a nos. 

 

Só após fazer algumas tentativas é que o repetidor volta a ligar. 

Está colocado numa zona onde tenho bom sinal de rede. 

  0      
  0      
#1
Options
1 Reply
Re:Luz de iniciação não fixa
2023-06-06 08:12:06

  @Amagui76 

 

Hello, do you mean power LED keeps blinking? or signal LED?

 

In addition, you mentioned something about disconnecting and reconnecting the ISP router, is the RE450 connected to your router via Ethernet cable? or via WiFi?

And is the internet working fine when the RE450 stays on?

 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 341

Replies: 1

Related Articles