IPSEC Branch to Branch and Branch to Head
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello friends
I have a Head Office and two Branch Offices.
I have an IPSec tunnel created between each Branch Office through to the Head Office.
The IPSec tunnels both come up and work.
I can get traffic to/from each Branch Office through to the Head Office.
However, I cannot get traffic from either Branch office through to the other Branch Office.
May I know what I'm doing wrong please
Dear @d0ugmac1 ,thank you kindly for your prompt response.
Below is what is setup at the moment and the Green tunnels are working fine.I added the remote subnets as per your suggestion and it does not make any difference, the Ipsec only shows the connections between the HEAD and the Two Branches.
when I'm creating a parallel tunnel, I have turned off the existing tunnels to the head office and added B1 as Responder and B2 as Initiator and that doesn't seem to work either.
Also i have Turned the existing Tunnel on between Head Office and B1 ,B2 and it did not make any difference,I have checked the ACL and there is none blocking any traffic between B1 and B2
