Router Hide all the 192

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Router Hide all the 192

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Router Hide all the 192
Router Hide all the 192
2023-06-09 02:01:03
Model: Archer AX1500  
Hardware Version: V1
Firmware Version:

I had an AC1200 Router to brought in Unifi Connection.

LAN Port 1Connection were attached to FORTINET Device to Link Connection to Out of Country running on 10.xx.xx.xx

LAN Port 2Connection to CISCO Router in Order to distribute the 192 and 10 connection to all of the Employee in the organization

10.xx.xx.xx was on a FIXED IP

192.168.0.1 was on Dynamic IP

 

When I connect another Router the Archer AX20 

I set it as AP Access Mode

In withn 10 minute time, the entire organization will be in 10.xx.xx.xx 

then the 192.xx.xx.xx will be hidden and gone

 

If I would like to get back the 192.168 environment, I had to turn off the Archer AX20.

May I know what can I do to overcome this issue?

  0      
  0      
#1
Options
1 Reply
Re:Router Hide all the 192
2023-06-09 08:02:22 - last edited 2023-06-11 23:17:52

  @JetSwan 

 

When in AP mode, AX20 just redistributes the IP subnet of the DHCP server on your main router - make sure that you've turned off the AX20 DHCP server.

This behavior can be caused by your network topology or main router configuration.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options