Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > Slow speed between multiple X50 to Ethernet device

< Deco

Slow speed between multiple X50 to Ethernet device

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Slow speed between multiple X50 to Ethernet device

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AndreasDpunkt

2023-09-18 07:09:49

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-09-18

Slow speed between multiple X50 to Ethernet device

2023-09-18 07:09:49

Model: Deco X50

Hardware Version: V12

Firmware Version: 1.1.0 Build 20230522 Rel. 68968

Hi all,

I use 3 X50 connected via WiFi. Internet and WiFi are working well.

I have a NAS connected to one satellite deco(also tried on main deco) via Ethernet. Another Ethernet device on the same deco has good performance. When I access the NAS via another deco, the speed is only about 100m/s although Internet speed and other WiFi devices via the same combination are gigabit-connected.

Any ideas?

Thanks!

3 Reply

Alexandre.

LV6

2023-09-18 19:55:13 - last edited 2023-09-18 19:55:22

Posts: 3994

Helpful: 2326

Solutions: 520

Stories: 0

Registered: 2020-10-22

Re:Slow speed between multiple X50 to Ethernet device

2023-09-18 19:55:13 - last edited 2023-09-18 19:55:22

@AndreasDpunkt

On your NAS, check what it reports for the negotiated speed of its Ethernet ports.

AndreasDpunkt

LV1

2023-09-18 20:06:21

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-09-18

Re:Slow speed between multiple X50 to Ethernet device

2023-09-18 20:06:21

@Alexandre. Thanks for your reply! The NAS says it's 1gbit...

Alexandre.

LV6

2023-09-18 20:14:29

Posts: 3994

Helpful: 2326

Solutions: 520

Stories: 0

Registered: 2020-10-22

Re:Slow speed between multiple X50 to Ethernet device

2023-09-18 20:14:29

@AndreasDpunkt

If you can, configure Deco mesh to run in Access Point mode, and check again. Switching a Deco to Access Point (AP) Mode

-----------------------

I have Deco M5 hardwired to the ISP router, running in AP mode. I have PC hardwired to that Deco.

I have two NAS servers hardwired to ISP router. It so happened, today I decided to move about terabyte of files from one NAS to another using PC hardwired to the Deco. The read and write speeds reach 350Mbps each, totalling 700Mbps. Not bad, considering file transfer overhead by PC itself.

Slow speed between multiple X50 to Ethernet device

Slow speed between multiple X50 to Ethernet device

Information

Voters 0

Tags