DHCP Server in standalone mode ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

DHCP Server in standalone mode ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
DHCP Server in standalone mode ?
DHCP Server in standalone mode ?
2023-10-07 02:06:51 - last edited 2023-10-16 06:45:39
Model: SG2210P  
Hardware Version: V5
Firmware Version: 5.0.6 Build 20230602 Rel.73473

Hi,

 

I have a TL-SG2210P in standalone mode  - I would like to use the DHCP Server option but cannot find any information on how to configure it.

I have created and enabled it under L3 Features, DHCP Server, configured the a pool but nowhere can I find how you then bind that to an interface on the switch so that it can allocate a dhcp address.

 

Any help appreciated.  

  0      
  0      
#1
Options
1 Accepted Solution
Re:DHCP Server in standalone mode ?-Solution
2023-10-08 07:40:25 - last edited 2023-10-16 06:45:39

  @GoKiwi 

think you can use this article: https://www.tp-link.com/en/support/faq/887/

it shows you how to config that.

ScReW yOu gUyS. I aM GOinG hoMe. —————————————————————— For heaven's sake, can you write and describe your issue based on plain fact, common logic and a methodologic approach? Appreciate it.
Recommended Solution
  3  
  3  
#2
Options
2 Reply
Re:DHCP Server in standalone mode ?-Solution
2023-10-08 07:40:25 - last edited 2023-10-16 06:45:39

  @GoKiwi 

think you can use this article: https://www.tp-link.com/en/support/faq/887/

it shows you how to config that.

ScReW yOu gUyS. I aM GOinG hoMe. —————————————————————— For heaven's sake, can you write and describe your issue based on plain fact, common logic and a methodologic approach? Appreciate it.
Recommended Solution
  3  
  3  
#2
Options
Re:DHCP Server in standalone mode ?
2023-10-10 02:01:32
As stated in the link mentioned by Tedd404 guy, you need to do the relevant configurations on the router and switch separately, and finally you need to set the gateway to the IP of the VLAN interface when configuring the IP pool.
  1  
  1  
#4
Options

Information

Helpful: 0

Views: 336

Replies: 2

Related Articles