Deco P9 defaults to wi-fi connection instead of powerline
My three new deco P9 powerline units connect to the faintest of wifi signal from my M9 plus. I bought the powerline P9s to remove the poor wifi. Is there a way I can tell the P9s not to look at wifi
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Start with this FAQ document from TP-Link: General Questions about the Powerline or PLC Backhaul Feature of Deco
- Copy Link
- Report Inappropriate Content
Start with this FAQ document from TP-Link: General Questions about the Powerline or PLC Backhaul Feature of Deco
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
AndrewF wrote
Thanks, I had already followed the advice in this doc before posting. I think i might have to send them back and drill hole for a cable sadly
If you have read that document you should have seen "Powerline Backhaul doesn't need to be turned on by any hardware or software switch, and it takes effect automatically" in it.
Powerline link takes priority over WiFi, which means: if P9s could connect over powerline they would.
Powerline technology is very sensitive to electrical wiring and what else is plugged. I was in the same situation: tried powerline adapters and they wouldn't work reliably at my house. Ended drilling holes in the walls and ceilings to bring Ethernet cable where I needed it to be. Spent time doing that, but have no regrets.
Just make sure you tested Ethernet cable before you pull it through the walls, especially if it is the long one.
By the way, you could still use P9s with Ethernet cables, Ethernet link takes priority over powerline.
Before you sent P9s back (if you decided to), TP-Link also recommends make P9 Main Deco. Chances are slim it'll change anything, but why not to try that? Changing the Main Unit for your Mesh Network
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 599
Replies: 3
Voters 0
No one has voted for it yet.